---

13.3.4 Power Management Home Services

The (gnu home services pm) module provides home services pertaining to battery power.

Variável: home-batsignal-service-type

Service for batsignal, a program that monitors battery levels and warns the user through desktop notifications when their battery is getting low. You can also configure a command to be run when the battery level passes a point deemed “dangerous”. This service is configured with the home-batsignal-configuration record.

Data Type: home-batsignal-configuration

Data type representing the configuration for batsignal.

warning-level (default: 15)

The battery level to send a warning message at.

warning-message (default: #f)

The message to send as a notification when the battery level reaches the warning-level. Setting to #f uses the default message.

critical-level (default: 5)

The battery level to send a critical message at.

critical-message (default: #f)

The message to send as a notification when the battery level reaches the critical-level. Setting to #f uses the default message.

danger-level (default: 2)

The battery level to run the danger-command at.

danger-command (default: #f)

The command to run when the battery level reaches the danger-level. Setting to #f disables running the command entirely.

full-level (default: #f)

The battery level to send a full message at. Setting to #f disables sending the full message entirely.

full-message (default: #f)

The message to send as a notification when the battery level reaches the full-level. Setting to #f uses the default message.

batteries (default: '())

The batteries to monitor. Setting to '() tries to find batteries automatically.

poll-delay (default: 60)

The time in seconds to wait before checking the batteries again.

icon (default: #f)

A file-like object to use as the icon for battery notifications. Setting to #f disables notification icons entirely.

notifications? (default: #t)

Whether to send any notifications.

notifications-expire? (default: #f)

Whether notifications sent expire after a time.

notification-command (default: #f)

Command to use to send messages. Setting to #f sends a notification through libnotify.

ignore-missing? (default: #f)

Whether to ignore missing battery errors.